Concrete Coatings Victoria

Concrete coatings and sealcoating in Esquimalt BC

Esquimalt mixes older detached houses with a lot of small strata and townhouse complexes, so we work both sides of the residential and commercial split here.

A residential two-car garage with a freshly installed flake epoxy floor coating in warm grey, reflecting the daylight.
  • Esquimalt is inside our regular service area, not a stretch
  • Moisture reading taken before any system gets specified
  • Diamond-ground preparation, itemised on the estimate
  • Written scope and cure schedule before work is booked

What Esquimalt surfaces throw at a coating

Being right on the water means more salt-laden air and more freeze-free but soaking-wet months. Coatings here are specified for moisture tolerance rather than for cold.

None of that changes the trade, but it does change the specification. We take the same reading and do the same preparation everywhere, then pick the system to suit what the surface in front of us is actually doing. A slab in Esquimalt and a slab three towns over can want two different primers for reasons that have nothing to do with the price of the job.

That is the whole reason we assess on site rather than quote off a photo. Estimates vary with condition, so we come out, measure, test and put the number in writing.

Book an assessment in Esquimalt

Tell us the surface and what it is doing. We will arrange a visit, take a reading and put the estimate in writing.

Get an estimate

Tell us what the surface is and what is wrong with it. We will arrange a site assessment, test the slab and put the estimate in writing. Estimates vary with condition, so we will not guess at a number before we have seen it.

So we can reach you to book the assessment.

We use what you send here to quote your job and nothing else. No mailing list.

Get an estimate