Concrete coatings and sealcoating in Sidney BC
Sidney is flatter, drier and closer to the water, with a lot of single-level homes and detached garages.
- Sidney is inside our regular service area
- Moisture reading taken before any system gets specified
- Diamond-ground preparation, itemised on the estimate
- Written scope and cure schedule before work is booked
What Sidney surfaces throw at a coating
Exposure to marine air is the main factor. Salt sits on a driveway surface and works into any open crack, so crack filling is the part of the job that decides how long the seal lasts.
That changes the specification, not the trade. We take the same reading and do the same preparation everywhere, then pick the system to suit what the surface in front of us is doing. A slab in Sidney and a slab three towns over can want two different primers.
What we do in Sidney
- Garage floor epoxyWe grind the slab back to clean concrete, test it for moisture, then build a flake or solid-colour coating that stops the dusting and shrugs off road salt.
- Concrete resurfacingA cementitious overlay bonded over your existing driveway, patio or walkway. Cracks get routed and filled first, so the overlay bonds to a repaired slab.
- Driveway sealcoatingAsphalt on the coast loses its binder to rain and UV long before it loses its shape. We clean, fill and seal so the surface stays flexible instead of ravelling.
- Parking lot line paintingStall lines, arrows, numbering and accessible-stall markings repainted on strata and commercial lots. Scheduled around your tenants, usually overnight.
- Parking lot sealcoatingCrack fill and sealer across the whole lot, then the lines go back down over a clean surface. Sealing and re-striping run as one job, in one closure.
Book an assessment in Sidney
Tell us the surface and what it is doing. We will arrange a visit, take a reading and put the estimate in writing.