Concrete coatings and sealcoating in Victoria BC
The core is heavy on pre-war and mid-century houses, so a lot of the garage slabs we look at were poured before anyone put a vapour barrier under them.
- Victoria is inside our regular service area
- Moisture reading taken before any system gets specified
- Diamond-ground preparation, itemised on the estimate
- Written scope and cure schedule before work is booked
What Victoria surfaces throw at a coating
An older slab with no barrier under it pushes ground moisture up through the concrete, which is the single most common reason a coating lifts. That is why the moisture test comes before the quote, not after.
That changes the specification, not the trade. We take the same reading and do the same preparation everywhere, then pick the system to suit what the surface in front of us is doing. A slab in Victoria and a slab three towns over can want two different primers.
What we do in Victoria
- Garage floor epoxyWe grind the slab back to clean concrete, test it for moisture, then build a flake or solid-colour coating that stops the dusting and shrugs off road salt.
- Concrete resurfacingA cementitious overlay bonded over your existing driveway, patio or walkway. Cracks get routed and filled first, so the overlay bonds to a repaired slab.
- Driveway sealcoatingAsphalt on the coast loses its binder to rain and UV long before it loses its shape. We clean, fill and seal so the surface stays flexible instead of ravelling.
- Parking lot line paintingStall lines, arrows, numbering and accessible-stall markings repainted on strata and commercial lots. Scheduled around your tenants, usually overnight.
- Parking lot sealcoatingCrack fill and sealer across the whole lot, then the lines go back down over a clean surface. Sealing and re-striping run as one job, in one closure.
Book an assessment in Victoria
Tell us the surface and what it is doing. We will arrange a visit, take a reading and put the estimate in writing.